Booting Linux... PROMLIB: Sun Boot Prom Version 0 Revision 0 Linux version 2.6.21.1 (daniel@neptune) (gcc version 3.4.4) #80 Wed Dec 5 17:55:15 CET 2007 ARCH: LEON Vendors Slaves Ahb masters: 0( 1: 3| 0): VENDOR_GAISLER GAISLER_LEON3 1( 1: 1c| 0): VENDOR_GAISLER GAISLER_AHBJTAG 2( 1: 24| 0): VENDOR_GAISLER GAISLER_ATACTRL Ahb slaves: 0( 4: f| 0): VENDOR_ESA ESA_MCTRL +0: 0x0 (raw:0x3e002) +1: 0x20000000 (raw:0x2000e002) +2: 0xa0000000 (raw:0xa003f002) 1( 1: 6| 0): VENDOR_GAISLER GAISLER_APBMST +0: 0x80000000 (raw:0x8000fff2) 2( 1: 4| 0): VENDOR_GAISLER GAISLER_LEON3DSU +0: 0x90000000 (raw:0x9000f002) 3( 1: 25| 0): VENDOR_GAISLER Unknown device 25 +0: 0x40000000 (raw:0x4003f002) +1: 0xfff00100 (raw:0x10fff3) 4( 1: 24|10): VENDOR_GAISLER GAISLER_ATACTRL +0: 0xfffa0000 (raw:0xa000fff3) Apb slaves: 0( 4: f| 0): VENDOR_ESA ESA_MCTRL + 0: 0x80000000 (raw:0xfff1) 1( 1: c| 2): VENDOR_GAISLER GAISLER_APBUART + 0: 0x80000100 (raw:0x10fff1) 2( 1: d| 0): VENDOR_GAISLER GAISLER_IRQMP + 0: 0x80000200 (raw:0x20fff1) 3( 1: 11| 8): VENDOR_GAISLER GAISLER_GPTIMER + 0: 0x80000300 (raw:0x30fff1) 4( 1: 1a| 0): VENDOR_GAISLER GAISLER_PIOPORT + 0: 0x80000500 (raw:0x50fff1) TYPE: Leon2/3 System-on-a-Chip Ethernet address: 0:0:0:0:0:0 CACHE: 2-way associative cache, set size 4k Boot time fixup v1.6. 4/Mar/98 Jakub Jelinek (jj@ultra.linux.cz). Patching kernel for srmmu[Leon2]/iommu node 2: /cpu00 (type:cpu) (props:.node device_type mid mmu-nctx clock-frequency uart1_baud uart2_baud ) PROM: Built device tree from rootnode 1 with 918 bytes of memory. DEBUG: psr.impl = 0xf fsr.vers = 0x7 Built 1 zonelists. Total pages: 7243 Kernel command line: console=ttyS0,38400 init=/sbin/init PID hash table entries: 128 (order: 7, 512 bytes) Todo: init master_l10_counter Attaching grlib apbuart serial drivers (clk:103hz): Console: colour dummy device 80x25 Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Memory: 28424k/32768k available (1704k kernel code, 4344k reserved, 208k data, 144k init, 0k highmem) Mount-cache hash table entries: 512 NET: Registered protocol family 16 No GRPCI controller found NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 1024 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP reno registered checking if image is initramfs...it isn't (no cpio magic); looks like an initrd Freeing initrd memory: 1328k freed io scheduler noop registered io scheduler cfq registered (default) grlib apbuart: 1 serial driver(s) at [0x80000100(irq 2)] grlib apbuart: system frequency: 103000 khz, baud rates: 38400 38400 ttyS0 at MMIO 0x80000100 (irq = 2) is a Leon RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize loop: loaded (max 8 devices) Activating Leon3 io port for smsc_lan91cxx (pio:80000500 mctrl:80000000) smc91x.c: v1.1, sep 22 2004 by Nicolas Pitre eth0: SMC91C11xFD (rev 2) at fd003300 IRQ 4 eth0: Ethernet addr: 00:13:14:15:16:17 Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx ATA-Controller at 0xfffa0000 IRQ 10 ioremap: done with statics, switching to malloc ide0: ATACTRL generic IDE interface hda: TOSHIBA THNCF1G02QG(, CFA DISK drive ide0 at 0xfd004040-0xfd004047,0xfd00c078 on irq 10 hda: max request size: 128KiB hda: 2000880 sectors (1024 MB) w/2KiB Cache, CHS=1985/16/63 hda: hda1 hda2 TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 10 IPv6 over IPv4 tunneling driver RAMDISK: Compressed image found at block 0 VFS: Mounted root (romfs filesystem) readonly. Freeing unused kernel memory: 144k freed init started: BusyBox v0.60.5 (2007.12.05-16:31+0000) multi-call binary Shell invoked to run file: /etc/init.d/rcS Command: #!/bin/sh Command: mount -t proc none /proc Command: mount -t sysfs none /sys Command: mount -t devpts devpts /dev/pts Command: Command: hostname sparky Command: Command: /sbin/ifconfig lo up 127.0.0.1 netmask 255.0.0.0 Command: /sbin/ifconfig eth0 up 192.168.0.80 eth0: link down ADDRCONF(NETDEV_UP): eth0: link is not ready Command: Command: route add 127.0.0.1 dev lo Command: route add default dev eth0 Command: Command: /bin/portmap & Please press Enter to activate this console. eth0: link up, 100Mbps, full-duplex, lpa 0xC5E1 ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready Sash command shell (version 1.1.1) /> cd /mnt /mnt> ls /mnt> cd .. /> mount /dev/hda1 /mnt /> ls -l mnt drwxr-xr-x 2 0 0 4096 Jun 4 2006 a drwxr-xr-x 2 0 0 4096 Jun 4 2006 bin drwxr-xr-x 2 0 0 4096 Jun 4 2006 boot drwxr-xr-x 15 0 0 40960 Jan 1 1970 dev drwxr-xr-x 15 0 0 4096 Jan 1 1970 etc drwxr-xr-x 5 1000 100 4096 Jun 4 2006 home drwxr-xr-x 3 0 0 4096 Jun 4 2006 lib drwx------ 2 0 0 4096 Jan 1 1970 lost+found drwxr-xr-x 5 0 0 4096 Jun 4 2006 mnt drwxr-xr-x 2 0 0 4096 Oct 6 1997 proc drwx--x--- 4 0 0 4096 Jan 1 1970 root drwxr-xr-x 2 0 0 4096 Jun 4 2006 sbin drwxrwxrwt 4 0 0 4096 Jun 4 2006 tmp drwxr-xr-x 17 0 0 4096 Jun 4 2006 usr drwxr-xr-x 13 0 0 4096 Jun 4 2006 var /> mount rootfs on / type rootfs (rw) /dev/ram on / type romfs (ro) none on /proc type proc (rw) none on /sys type sysfs (rw) devpts on /dev/pts type devpts (rw) /dev/hda1 on /mnt type ext2 (rw)